Mounting the unit on the stand

Use an all-purpose clamp (APC-33, sold separately) or a pad stand (PDS-20/PDS-10, sold separately) when mounting the SPD-SX PRO onto a stand.

NOTE

  1. Be sure to use the screw found on the bottom of the SPD-SX PRO. If you use different screws, the unit may malfunction.
  2. Before turning the unit over, lay out several pieces of newspaper or magazines at the four corners and on both sides of this unit to protect the buttons, knobs and other controls from damage. When doing so, make sure to place the unit so that the buttons, knobs and other controls do not get damaged.
  3. When turning the unit over, handle it carefully so as not to drop or overturn it.
  4. Do not store this unit upside down. The floor or other surface may press against the pads, squashing the pad sensors and causing them to malfunction.