Setting the Output Destination (OUTPUT ASSIGN)
On the OUTPUT ASSIGN screen, press the [F1]–[F5] buttons to select the parameters to configure.
The parameters are the same as those that are set in the OUTPUT/EFFECTS screen. On this OUTPUT ASSIGN screen, you can check the parameters as a list.
PAD OUT (PAD OUTPUT)
Specifies the output destination for the pad audio.
- Select the pad or trigger to set using the cursor [ã] [â] buttons, and select the output destination using the [-] [+] buttons.
- The output of each trigger is routed to the outputs marked in blue on the screen.
- Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.
Button | Explanation |
|---|---|
[SHIFT] + [F6] (SET ALL) | Copies the output settings to multiple PAD/TRIGGER IN/FOOT SW all at once. |
EFFECT OUT (EFFECT OUTPUT)
Sets the output destination for audio from MFX 1-4 and from the side chain compressor.
- Select the pad or trigger to set using the cursor [ã] [â] buttons, and select the output destination using the [-] [+] buttons.
- Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.
PAD DIR (PAD DIRECT)
Set this when you want to output the pad sounds to DIRECT OUT.
- Select the pad or trigger to set using the cursor [ã] [â] buttons, and select the output destination using the [-] [+] buttons.
- Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.
Button | Explanation |
|---|---|
[SHIFT] + [F5] (COPY) | Copies the direct out settings. |
[SHIFT] + [F6] (SET ALL) | Copies the direct out settings to multiple PAD/TRIGGER IN/FOOT SW all at once. |
EFFECT DIR (EFFECT DIRECT)
Set this when you want to output the MFX 1-4 and side chain compressor audio to DIRECT OUT.
- Select the pad or trigger to set using the cursor [ã] [â] buttons, and select the output destination using the [-] [+] buttons.
- Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.
SC CTRL (SIDE CHAIN CTRL)
Turn this on when using the pad sounds as the side chain control signal.
- Select the pad to trigger to set using the cursor [ã] [â] buttons, and use the [-] [+] buttons to turn this off/on.
- Press the [F6] (EXIT) button to return to the OUTPUT / EFFECTS screen.