MASTER COMP Settings

Here’s how to configure the settings for the stereo compressor (master comp) that are applied at the final stage of the master out.

Parameter

Value

Explanation

Type

SINGLE SOFT COMP、SINGLE HARD COMP、SINGLE LIMITER、2BAND SOFT COMP、2BAND HARD COMP、2BAND LIMITER

Selects the character of the compressor.

  • When you edit the parameters, all parameters of the master comp change to match the type.
    You can then adjust each parameter as necessary.
    Depending on the settings of these parameters, the resulting effect might not match the Type setting.

Split Freq

SINGLE, 10–16000Hz

Adjusts the bandwidth of the compressor.

When the compressor bandwidth is “SINGLE”, this effect operates as a single-band compressor only on the high range.

Threshold (*1)

-60–0 dB

Adjusts the volume level at which compression starts.

Gain (*1)

-60–+24 dB

Adjusts the compressor output level.

Attack (*1)

0.1–100 ms

Adjusts how long it takes before compression is applied.

Release (*1)

10–1000 ms

Adjusts how long it takes before the compression returns to normal.

Ratio (*1)

1:1–INF:1

Adjust the compression ratio.

Knee (*1)

HARD, SOFT1–3

Adjusts the attack of the sound at the moment compression is applied.

  1. If Split Freq is set to something other than “SINGLE”, the low range and high range can be set independently.

 

Button

Explanation

[F2] LOW SOLO

When “Split Freq” is not set to “SINGLE” and the compressor is operating as a two-band compressor, you can individually audition the low- and high-frequency ranges.

  • These settings are reset if you perform any of the following operations.
  • Respecify the Type parameter as single band compressor
  • Set the Split Freq parameter to “SINGLE”
  • Exit the MASTER COMP screen

[F3] HIGH SOLO

[F6] (ON/OFF)

Turns the MASTER COMP on/off.