Copying a Kit and Swapping Two Kits (TOOLS-COPY KIT)

Here’s how to copy the settings of a kit and to exchange the settings of two kits.

  1. On the KIT screen, press the [F5] (TOOLS) button.
  2. This opens the TOOLS window.
  3. Use the cursor [à] [á] [ã] [â] buttons to select “COPY KIT” and press the [ENTER] button.
  4. The COPY KIT screen appears.
  6. Use the cursor [à] [á] buttons to select a parameter, and then use the [-] [+] buttons to change the setting.

  7. Parameter

    Value

    Explanation

    From

    USER, USB MEMORY 1–99

    Copy source kit location

    USER: Copies data from user memory. You can swap (exchange) the copy source and copy destination kits, but only if the copy source is in user memory.

    USB MEMORY 1–99: Copies kits from backup data saved on a USB flash drive.

    Kit number

    Copy source kit number

    To

    Kit number

    Copy/exchange destination kit number

  8. Press the [F6] button to copy, and the [F5] button to exchange.

  9. Button

    Explanation

    [F5] (EXCHANGE)

    Exchanges the kit in the “From” area with the kit in the “To” area.

    [F6] (COPY)

    Copies (overwrites) the kit in the “From” area to the kit in the “To” area. This erases the kit data saved in the “To” area.

  10. A confirmation message appears.
  11. If you decide to cancel, select “CANCEL” and press the [ENTER] button.
  12. Use the cursor [ã] [â] buttons to select “OK”, and press the [ENTER] button.
  13. After “Completed!” appears, the display returns to the previous screen.