Restoring the Factory Settings

NOTE

Once you execute the following steps, all the data in the SPD-SX PRO is overwritten. Be sure to save any important data to a USB flash drive before doing this.

Creating a USB flash drive for updating

  1. Download and decompress the factory default settings data (SPD-SX PRO FACTORY RESTORE DATA) from the Web page listed below.
  2. https://www.roland.com/global/products/spd-sx_pro/downloads/
  3. Insert your USB flash drive into the USB port of the computer.
  4. Copy the “Roland” folder that you decompressed in step 1 to the root directory of the USB flash drive (the directory that opens immediately when you open the drive).

  5. MEMO

    Copy the entire “Roland” folder, not just the contents.

  6. Follow the instructions below to remove the USB flash drive from your computer.
  7. For Windows users:
  8. Click the “Remove Hardware” icon shown on the taskbar at the lower right corner of the screen to disconnect (eject) the USB flash drive, and then remove it from the computer.
  9. For Mac users:
  10. Drag and drop the icon for the USB flash drive into the Trash. Once the connection to the USB flash drive has been severed, unplug the drive from your computer.

Loading the factory default settings data from a USB flash drive

  1. Connect a USB flash drive to the USB MEMORY port of the SPD-SX PRO.
  2. Press the [MENU] button on the SPD-SX PRO.
  3. Use the cursor to select “BACKUP”, and then press the [ENTER] button.
  4. Use the cursor to select “LOAD”, and press the [ENTER] button. The USB MEMORY LOAD ALL screen appears.
  5. Use the cursor [-] [+] buttons to select “1.Contents_V****” and press the [F6] (LOAD) button.
  6. A confirmation message appears.
  7. Use the cursor [ã] [â] buttons to select “OK”, and press the [ENTER] button.
  8. This loads the factory default settings data.