BPM Looper

Loops a short portion of the input sound. This can automatically turn the loop on/off in synchronization with the rhythm.

Parameter

Value

Explanation

Length

0–127

Specifies the length of the loop.

Rate (sync sw)

OFF, ON

If this is ON, the rate synchronizes with the tempo of the rhythm.

Ø “Setting the kit tempo (KIT TEMPO)”

  • This is valid only when Loop Mode is “AUTO”.

Rate (Hz)

0.05–10.00 [Hz]

Cycle at which the loop automatically turns on/off

Rate (note)

Note

Ø “Note”

On Timing

1–8

Specifies the timing within the cycle at which the loop automatically starts (which step of the eight timing divisions at which the sound is heard).

  • This is valid only when Loop Mode is “AUTO”.

On Length

1–8

Specifies the length at which the loop automatically ends within the cycle (the number of times that the 1/8-length of sound is heard).

  • This is valid only when Loop Mode is “AUTO”.

Loop Mode (*1)

OFF, AUTO, ON

If this is AUTO, the loop automatically turns on/off in synchronization with the rhythm.

  • If the effect is recalled with this ON, this parameter must first be set to something other than ON in order to make the loop operate.

Level

0–127

Output Level

*1: This parameter corresponds to MFX CTRL. For details, refer to “Controlling the MFX with the PAD EDIT [1] [2] Knobs (MFX Ctrl)”.

*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to “Controlling the MASTER EFFECT with the MASTER EFFECT Knob (MASTER EFFECT CTRL)”.