Other settings and features
If a pad is not recognized
If your pads are not recognized even when you connect the DH-10 to which they are already paired, follow the steps below.
- Select [MENU] Ó “SYSTEM”.
- Use the cursor [à] [á] [ã] [â] buttons to select “PAD/TRIG IN” and press the [ENTER] button.
- The PAD / TRIG IN screen appears.
- Press the [F6] (DrumLink) button and then press the [F1] (HUB) button.
- The DrumLink - HUB screen appears.
- Press the [F6] (DrumLink) button to turn DrumLink off.
- Press the [F6] (DrumLink) button again to turn DrumLink on.
- If the pads are still not recognized after you do this, disconnect the SPD-SX PRO from the DH-10 and try connecting them again.
Checking the remaining battery power
You can check the remaining battery power for each pad from the Drumlink - TRIGGER BASIC tab, the DrumLink - TRIGGER CURVE tab, and the DrumLink - TRIGGER OPTIONS/ADVANCED tab.
When you strike a pad, the built-in LED on the WT-10 lights up.
If the pad LED does not light up even after you strike the pad, replace the batteries.
NOTE
- Use AA-size alkaline batteries.
- The fluid in the batteries may leak if the remaining battery level gets too low. Replace the batteries as soon as possible.
- Remove the batteries from the pads when you are not using the pads for an extended period of time.
Unpairing the SPD-SX PRO and the pads (unpairing)
Here’s how to unpair the SPD-SX PRO from the pads.
- Select [MENU] Ó “SYSTEM”.
- Use the cursor [à] [á] [ã] [â] buttons to select “PAD/TRIG IN” and press the [ENTER] button.
- The PAD / TRIG IN screen appears.
- Press the [F6] (DrumLink) button.
- The DrumLink screen appears.
- Press one of the [F2] (BASIC)–[F4] (OPT/ADV) buttons.
- Press the [F5] (TOOLS) button to display the TOOLS window.
- Strike to select the pad that you want to unpair.
- You can also select a pad by pressing the cursor [ã] and [â] buttons while holding down the [ENTER] button.
- Use the cursor [à] [á] [ã] [â] buttons to select “UN-PAIR”, and press the [ENTER] button.
- Use the cursor [à] [á] [ã] [â] buttons to select “OK”, and press the [ENTER] button.
- After the message appears, strike the selected pad to unpair it.
MEMO
When the cursor is on a paired pad in the DrumLink - HUB screen, you can also unpair the pad by pressing [F6] (UNPAIR) while holding down the [SHIFT] button.
Updating the firmware
To update the firmware for the DH-10 or the WT-10, connect the DH-10 to your computer and use the DWe Control application.
See the DH-10 and WT-10 product support pages for update instructions.