Loading an SPD-SX backup file (LOAD SPD-SX)

This converts any kit from the SPD-SX backup data and loads it into the SPD-SX PRO.

Saving the loaded data (operations on the SPD-SX)

On the SPD-SX, execute SAVE (USB MEMORY).
Select MENU Ó UTILITY Ó SAVE (USB MEM).
Use the cursor [à] [á] buttons to select “ALL” and press the [ENTER] button.
NOTE
Backup files saved with “KIT+SETTINGS” cannot be loaded into the SPD-SX PRO. Be sure to save as “ALL”.
Use the cursor [à] [á] buttons to select the save destination, and press the [ENTER] button.
Add a name as needed.
Press the [ENTER] button.
A confirmation message appears.
If you decide to cancel the operation, press the [EXIT] button.
Press the [ENTER] button.

Connect the USB flash drive containing the backup data of the SPD-SX to the USB port of the SPD-SX PRO.
Save destination for backup data
Select the [MENU] button Ó “BACKUP” Ó “LOAD SPD-SX” in that order, and press the [ENTER] button.
Select the SPD-SX backup file that includes the kit(s) you wish to load.
Select the check boxes of the kits to load.
Function
Explanation
[F1] (CHECK)
Selects/deselects the selected kits.
[F2] (CHECK ALL)
Selects/deselects all of the kits.
Use the [-] [+] buttons or the dial to select the load destination, and press the [F6] (LOAD) button.
On the confirmation message, select “OK”, and press the [ENTER] button.
The following screen is shown once loading is completed.
NOTE
1. If the SPD-SX backup data includes WAV files that are extremely short or that are longer than 60 minutes, these WAV files are not loaded into the SPD-SX PRO.
2. Parameters such as for effects or for output routing cannot be loaded (this is due to the difference in specifications between the SPD-SX and the SPD-SX PRO).
3. Parameters such as volume which use different units respectively for the SPD-SX and SPD-SX PRO are automatically converted to the optimum values. Adjust the values after loading if they are not to your liking.
Press the [ENTER] button to finish.

The following data from the SPD-SX can be used on the SPD-SX PRO.


Parameter on the SPD-SX	Support status (µ: supported, –: not supported)
WAVE Data	µ
WAVE NAME	µ
WAVE START/END	µ
WAVE TEMPO	µ
WAVE TAG	-

KIT NAME	µ
KIT SUB NAME	µ
KIT VOLUME	µ
KIT TEMPO	µ
PAD LINK	µ

WAVE Assign	µ
VOLUME	µ
PAN	µ
TEMPO SYNC	µ
MUTE GROUP	µ

LOOP	µ
TRIG TYPE	µ
DYNAMICS	µ
POLY/MONO	µ

PAD CH	µ
MIDI NOTE#	µ
EXT CTRL	µ
GATE TIME	µ

Effect parameters	-
OUTPUT parameters	-
SYSTEM parameters	-

Function	Explanation
[F1] (CHECK)	Selects/deselects the selected kits.
[F2] (CHECK ALL)	Selects/deselects all of the kits.