REVERB

This effect adds reverberation to the sound.

Parameter	Value	Explanation
ON/OFF	OFF, ON	Turns this effect on/off.
TYPE	HALL S	Simulates the reverberation in a concert hall. Provides clear and spacious reverberations.
	HALL M	Simulates the reverberation in a concert hall. Provides mild reverberations.
	PLATE	Simulates plate reverberation (a reverb unit that uses the vibration of a metallic plate). Provides a metallic sound with a distinct upper range.
	ROOM S	Simulates the reverberation in a small room. Provides warm reverberations.
	ROOM L	Simulates the reverberation of a room larger than ROOM S.
	AMBIENCE	Simulates an ambience mic (off-mic, placed at a distance from the sound source) used in recording and other applications. Rather than emphasizing the reverberation, this reverb is used to produce a sense of openness and depth.
	SPRING	This simulates the sound of a guitar amp’s built-in spring reverb.
	SHIMMER	Simulates reverberation with a distinctively sparkling high-frequency range.
TIME	0.1 s–10.0 s	Adjusts the length (time) of reverberation.
LEVEL	0–100	Adjusts the volume of the reverb sound.
DENSITY	1–10	Adjusts the density of the reverb sound.
TONE	-50–0–+50	Adjusts the tonal character of the reverb.
PRE-DELAY	0 ms–200 ms	Adjusts the time until the reverb sound starts to output.
LOW CUT	FLAT, 20.0 Hz–12.5 kHz	Sets the frequency at which the low cut filter begins to take effect. When “FLAT” is selected, the low cut filter has no effect.
HIGH CUT	630 Hz–12.5 kHz, FLAT	Sets the frequency at which the high cut filter begins to take effect. When FLAT is selected, the high cut filter has no effect.
DIRECT	0–100	Adjusts the volume of the direct sound.
LOW DAMP	-50–0–+50	Adjusts the amount of attenuation for the low frequency region.
HIGH DAMP	-50–0–+50	Adjusts the amount of attenuation for the high frequency region.
PITCH 1 PITCH 2	-24–+24	Adjusts the amount of pitch shift.
PITCH LVL 1 (PITCH LEVEL 1) PITCH LVL 2 (PITCH LEVEL 2)	0–100	Adjusts the volume of the pitch shifter.