MIDI SETTING

Parameter	Value	Explanation
RX CH	This sets the MIDI channel used for receiving MIDI messages.
RX CH	CH1–CH16	Specifies the receive channel.
TX CH	Sets the MIDI channel used for transmitting MIDI messages.
	CH1–CH16	Specifies the transmit channel.
	RX CH	Transmits on the same channel as the RX CHANNEL.
MIDI IN THRU	This specifies the connector from which to output the MIDI messages that are received at the MIDI IN connector.
	OFF	MIDI messages are not transmitted.
	MIDI OUT	Messages are transmitted from the MIDI OUT connector.
	USB OUT	Messages are transmitted from the USB port.
	MIDI&USB	Output from the USB port and the MIDI OUT connector.
USB IN THRU	This specifies the connector from which to output the MIDI messages that are received at the USB port.
	OFF	MIDI messages are not transmitted.
	MIDI OUT	Messages are transmitted from the MIDI OUT connector.
	USB OUT	Messages are transmitted from the USB port.
	MIDI&USB	Output from the USB port and the MIDI OUT connector.
SYNC	This setting determines the basis used for synchronizing the timing for effect modulation rates and other time-based parameters. When you have an external MIDI device connected, the MASTER BPM is then synchronized to the external MIDI device’s tempo, thus disabling the MASTER BPM setting. To enable setting of the MASTER BPM, set to “INTERNAL.” When synchronizing performances to the MIDI Clock signal from an external MIDI device, timing problems in the performance may occur due to errors in the MIDI Clock.
	AUTO	Operations are synchronized to MIDI clock messages received via MIDI or USB. However, operations are automatically synchronized to the EX-4’s internal clock if the , is unable to receive the external Clock.
	INTERNAL	Operations are synchronized to the EX-4’s internal Clock.
	MIDI (AUTO)	Operations are synchronized to the MIDI Clock received via MIDI. However, operations are automatically synchronized to the EX-4’s internal clock if the , is unable to receive the external Clock.
	USB (AUTO)	Operations are synchronized to the USB Clock received via USB. However, operations are automatically synchronized to the EX-4’s internal clock if the , is unable to receive the external Clock.
CLOCK OUT	Specifies whether MIDI clock will be output from the EX-4.
	OFF	MIDI clock is not output.
	ON	MIDI clock is output.
PDL1 CC PDL2 CC CTL1(3) CC CTL2(4) CC EXP CC	Specifies the controller number when transmitting pedal operations as control change messages.
	OFF	Control Change messages are not output.
	CC#1–CC#31, CC#64–CC#95	Pedal operations are transmitted using the specified controller number.