HARMONIST

Harmonist is an effect where the amount of shifting is adjusted according to an analysis of the guitar input, allowing you to create harmony based on diatonic scales.

Parameter

Value

Explanation

ON/OFF

OFF, ON

Turns this effect on/off.

VOICE

Selects the number of voices for the pitch shift sound.

1 VOICE

One-voice pitch-shifted sound output in mono.

2 MONO

Two-voice pitch-shifted sound (HR1, HR2) output in mono.

2 STEREO

Two-voice pitch-shifted sound (HR1, HR2) output through left and right channels.

1: HARMONY

2: HARMONY*1

-2oct, ~+2oct

This determines the pitch of the sound added to the input sound, when you are making a harmony.

It allows you to set it by up to 2 octaves higher or lower than the input sound.

1: LEVEL

2: LEVEL*1

0–100

Adjusts the volume of the harmony sound.

1: PRE-DELAY

2: PRE-DELAY*1

0–300ms, BPMŌ–ŀ

Adjusts the time from when the direct sound is heard until the harmonist sounds are heard. Normally you can leave this set at 0 ms.

  • When set to BPM, the value of each parameter will be set according to the value of the “MASTER BPM” specified for each memory. This makes it easier to achieve effect sound settings that match the tempo of the song.
  • If, due to the tempo, the time is longer than the range of allowable settings, it is then synchronized to a period either 1/2 or 1/4 of that time.
  • ŀ is a double whole note, which is twice as long as a whole note.

1: FEEDBACK

0–100

Adjusts the feedback amount of the harmonist sound.

DIRECT

0–100

Adjusts the volume of the direct sound.

KEY

C (Am)–B (G#m)

The key setting corresponds to the key of the song (#, b) as follows.

  1. Can be set when VOICE is set to 2 MONO or 2 STEREO.