GUITAR SYNTH

This processes the guitar input sound to produce a synth sound.

When you use a guitar synthesizer, observe the following points.
Because of the need to analyze the pitch, chords (two or more sounds played simultaneously) cannot be played. Be sure to mute all the other strings and play only one note at a time.
When you are to play the next string while a certain sound is still playing, mute the previous sound and then play the next one with a clear attack. If the unit cannot detect the attack, it may not sound correctly.
The sensitivity may vary according to the guitar’s TONE knob and pickup type.

Parameter	Value	Explanation
TYPE	Selects a wave type which the synth sound is based.
	SAW	Processes the inputted guitar sound to create a sawtooth wave signal.
	SQUARE	Processes the inputted guitar sound to create a square wave signal.
FREQ	0–100	Adjusts the frequency at which the harmonic contents of the sound are cut off.
RESO	0–100	Adjusts the amount of resonance (and the tone coloration) in the synth sound. The higher the value, the more the synth tone coloration is emphasized.
FILTER SENS	0–100	Adjusts the amount of filtering applied in response to the input.
FILTER DECAY	0–100	This sets the time needed for the filter to finish its sweep.
FILTER DEPTH	0–100	Adjusts the depth of the filter. When the value is higher, the filter will change more drastically.
LEVEL	0–100	Adjusts the volume of the synth sound.
DIRECT	0–100	Adjusts the volume of the direct sound.