USB settings

  1. On the top screen, press the [] button.
  2. Turn the [3] knob to select “USB”, and then press the [3] knob.
  3. The USB screen appears.

  4. Parameter

    Value

    Explanation

    MODE

    2 ch,
    MULTI-CH,
    Windows

    Selects the GO:MIXER STUDIO output mode.

    • You must turn the unit off and on again to enable this setting.

    Ø “Setting the operation mode (USB driver)”

    SOURCE

    DIRECT,
    PREFADER,
    POSTFADER

    Sets how the audio (channels aside from MIX L/R) is output when “MULTI CH, Windows” is set in MODE.

    DIRECT: The signal after input gain adjustment to which EQ or effects have not been applied is output to each channel via USB.

    PREFADER: The signal before volume adjustment is output to each channel via USB. Use this when you want to adjust the mix balance using your DAW or other software.

    POSTFADER: The signal that has been adjusted for mix balance is output to each channel via USB.

    SMP RATE

    44.1kHz,
    48kHz,
    96kHz,
    192kHz

    Selects the sample rate.

    • You must turn the unit off and on again to enable this setting.
    • When “2 ch” is selected for MODE, the sample rate is set to a fixed value of 48 kHz.
    • When the value is 192 kHz, the number of IN/OUT channels changes.
      Ø “Input/output specifications for each mode”
    • The effects that can be used change when the value is 96 kHz or 192 kHz.
      Ø “Effect list for each channel”
  5. Press the [] button.
  6. If you have changed the mode or sample rate, a confirmation message to restart the unit is shown.

  7. MEMO

    1. If you have not changed the mode or sample rate, the display returns to the MENU screen.
    2. If you decide to cancel, press the [] button.
  8. Press the [3] knob.
  9. The unit automatically restarts, and the settings are updated.