REVERB

Chain

Palette

This effect adds reverberation to the sound.

Parameter

Value

Explanation

ON/OFF

OFF, ON

Turns this effect on/off.

TYPE

HALL S

Simulates the reverberation in a concert hall. Provides clear and spacious reverberations.

HALL M

Simulates the reverberation in a concert hall. Provides mild reverberations.

PLATE

Simulates plate reverberation (a reverb unit that uses the vibration of a metallic plate). Provides a metallic sound with a distinct upper range.

ROOM

Simulates the reverberation in a small room. Provides warm reverberations.

STUDIO

Simulates an ambience mic (off-mic, placed at a distance from the sound source) used in recording and other applications. Rather than emphasizing the reverberation, this reverb is used to produce a sense of openness and depth.

TIME

0.1 s–10.0 s

Adjusts the length (time) of reverberation.

EFFECT LEVEL

0–100

Adjusts the volume of the reverb sound.

DENSITY

1–10

Adjusts the density of the reverb sound.

PRE-DELAY

0ms–200ms

Adjusts the time until the reverb sound starts to output.

LOW CUT

FLAT, 20.0 Hz–800 Hz

Sets the frequency at which the low cut filter begins to take effect. When “FLAT” is selected, the low cut filter has no effect.

HIGH CUT

630 Hz–12.5 kHz, FLAT

Sets the frequency at which the high cut filter begins to take effect. When FLAT is selected, the high cut filter has no effect.

DIRECT LEVEL

0–100

Adjusts the volume of the direct sound.

CARRYOVER

OFF, ON

Sets whether to make the sound of the effect carry over or not after you turn it off.