DIVIDER／MIXER

Chain (DIVIDER)	Chain (MIXER)	Palette

Within the effect chain, the point where the signal is split into channels “A” and “B” is called the “divider” and the point where the two signals are recombined is called the “mixer”.

DIVIDER: You can use the divider to switch between channels “A” and “B”, to assign strongly picked notes and softly picked notes to different channels, or to assign different frequency bands of your guitar sound to different channels.

MIXER: Lets you adjust the volume balance of channels “A” and “B”, place them in the stereo field, or slightly delay the sound of channel “B” to produce a spacious sound.

When you drag the icon from the palette to the effect chain, the divider and mixer are automatically added to the chain.
The divider and mixer both share a single place in the chain.

DIVIDER

Parameter	Value	Explanation
MODE	SINGLE	Use only one channel, either “A” or “B”.
MODE	DUAL	Use the two channels “A” and “B”.
CH SELECT ^*1	A, B	Selects the channel to use.
MIX MODE ^*1	SWITCH		When you use CH SELECT to select a channel, the divider switches the signal routing. This lets you cut out the floor noise or other noise from effects included in the channel before switching, when the channel is switched.
MIX MODE ^*1	MIX		When you use CH SELECT to select a channel, the mixer switches the signal routing. This lets you carry over the tail end of effects included in the channel before switching, when the channel is switched.
A:DYNAMIC ^2 B:DYNAMIC ^2	OFF	DYNAMIC will not be used.
	POLARITY+	Only notes picked more strongly than the DYNA SENS setting will be output.
	POLARITY-	Only notes picked more softly than the DYNA SENS setting will be output.
A: DYNAMIC SENS ^2 B: DYNAMIC SENS ^2	0–100	Specifies the picking sensitivity.
A: FILTER ^2 B: FILTER ^2	OFF	The filter will not be used.
	LPF	Only the region below the cutoff frequency will be output.
	HPF	Only the region above the cutoff frequency will be output.
A: CUTOFF FREQ ^2 B: CUTOFF FREQ ^2	100 Hz, 125 Hz, 160 Hz, 200 Hz, 250 Hz, 315 Hz, 400 Hz, 500 Hz, 630 Hz, 800 Hz, 1.00 kHz, 1.25 kHz, 1.60 kHz, 2.00 kHz, 2.50 kHz, 3.15 kHz, 4.00 kHz	Specifies the cutoff frequency.

Setting available when MODE is set to SINGLE.
Setting available when MODE is set to DUAL.

MIXER

Parameter	Value	Explanation
MODE	STEREO	Channels “A” and “B” will be mixed and output in stereo.
MODE	PAN L/R	Channels “A” and “B” will be assigned respectively to the L and R OUTPUT jacks.
A LEVEL B LEVEL	0–100	Adjusts the volume of the channel.
A/B BALANCE	100:0–0:100	Adjusts the volume balance of channels “A” and “B”. This is shown only if DIVIDER MODE is set to “DUAL”.
SPREAD	0–100	Slightly delays the sound of channel “B” to make the sound more spacious. This is shown only if DIVIDER MODE is set to “DUAL”.