MASTER
Chain |
|---|
|
The following are settings that apply to all memories.
Parameter | Value | Explanation | |
|---|---|---|---|
MEMORY LEVEL | 1–200 | Sets the volume of the memory. | |
BPM | 40–250 | Adjusts the BPM value for each memory. BPM (beats per minute) indicates the number of quarter note beats that occur each minute. | |
KEY | C (Am)–B (G#m) | This sets the key for the HARMONIST. | |
INPUT SETTING | SYSTEM, 1-10 | Select the guitar (input level) that’s connected to the INPUT jack. You can set a different guitar to connect for each memory. When you select “SYSTEM”, the setting matches that which is selected in the INPUT SETTINGS of IN/OUT SETTING. | |
AMP CTL1, AMP CTL2 | OFF | Guitar amplifier (Channel switching jack)
| By connecting your guitar amp’s channel switching jack to the GX-100’s AMP CONTROL jack, you can then use Amp Control to switch the amp channel. This combining of the GX-100 and the amp channels allows you to get an even wider variety of distortion sounds. Since the Amp Control setting is saved as one of the effects parameters to each individual memory, switching between memories lets you switch between guitar amp channels.
|
ON | Guitar amplifier (Channel switching jack)
| ||
CARRYOVER | OFF, ON | You can specify whether the effect sound carries over when you switch memories. | |
TEMPO HOLD | OFF, ON | Specifies whether the tempo (BPM) changes or stays the same when you switch between memories. | |
