MIDI SETTING

Parameter	Value	Explanation
RX CHANNEL	This sets the MIDI channel used for receiving MIDI messages.
RX CHANNEL	CH1–CH16	Specifies the receive channel.
TX CHANNEL	Sets the MIDI channel used for transmitting MIDI messages.
	CH1–CH16	Specifies the transmit channel.
	RX CH	Transmits on the same channel as the RX CHANNEL.
MIDI IN THRU	This specifies the connector from which to output the MIDI messages that are received at the MIDI IN connector.
	OFF	MIDI messages are not transmitted.
	MIDI OUT	Messages are transmitted from the MIDI OUT connector.
	USB OUT	Messages are transmitted from the USB port.
	USB & MIDI	Output from the USB port and the MIDI OUT connector.
USB IN THRU	This specifies the connector from which to output the MIDI messages that are received at the USB port.
	OFF	MIDI messages are not transmitted.
	MIDI OUT	Messages are transmitted from the MIDI OUT connector.
	USB OUT	Messages are transmitted from the USB port.
	USB & MIDI	Output from the USB port and the MIDI OUT connector.
SYNC CLOCK	This setting determines the basis used for synchronizing the timing for effect modulation rates and other time-based parameters. When you have an external MIDI device connected, the MASTER BPM is then synchronized to the external MIDI device’s tempo, thus disabling the MASTER BPM setting. To enable setting of the MASTER BPM, set to “INTERNAL”. When synchronizing performances to the MIDI Clock signal from an external MIDI device, timing problems in the performance may occur due to errors in the MIDI Clock.
	AUTO	Operations are synchronized to MIDI clock messages received via MIDI or USB. However, operations are automatically synchronized to this unit’s internal clock if the GX-100 is unable to receive the external Clock.
	INTERNAL	Operations are synchronized to the GX-100’s internal Clock.
	MIDI (AUTO)	Operations are synchronized to the MIDI Clock received via MIDI. However, operations are automatically synchronized to this unit’s internal clock if the GX-100 is unable to receive the external Clock.
	USB (AUTO)	Operations are synchronized to the USB Clock received via USB. However, operations are automatically synchronized to this unit’s internal clock if the GX-100 is unable to receive the external Clock.
CLOCK OUT	Specifies whether MIDI clock will be output from the GX-100.
	OFF	MIDI clock is not output.
	ON	MIDI clock is output.
NUM1 CC# NUM2 CC# NUM3 CC# NUM4 CC# BANK á CC# BANK à CC# EXP1 SW CC# CTL1 CC# CTL2 CC# CTL3 CC# CTL4 CC# EXP1 CC# EXP2 CC#	Specifies the controller number when transmitting pedal operations as control change messages.
	OFF	Control Change messages are not output.
	CC#1～CC#31、 CC#64～CC#95	Pedal operations are transmitted using the specified controller number.