MIDI SETTING

Parameter

Value

Explanation

RX CHANNEL

This sets the MIDI channel used for receiving MIDI messages.

CH1–CH16

Specifies the receive channel.

TX CHANNEL

Sets the MIDI channel used for transmitting MIDI messages.

CH1–CH16

Specifies the transmit channel.

RX CH

Transmits on the same channel as the RX CHANNEL.

USB IN THRU

This specifies the connector from which to output the MIDI messages that are received at the USB port.

OFF

MIDI messages are not transmitted.

USB OUT

Messages are transmitted from the USB port.

SYNC CLOCK

This setting determines the basis used for synchronizing the timing for effect modulation rates and other time-based parameters.

  • When you have an external MIDI device connected, the MASTER BPM is then synchronized to the external MIDI device’s tempo, thus disabling the MASTER BPM setting. To enable setting of the MASTER BPM, set to “INTERNAL”.
  • When synchronizing performances to the MIDI Clock signal from an external MIDI device, timing problems in the performance may occur due to errors in the MIDI Clock.

INTERNAL

Operations are synchronized to the GX-10’s internal Clock.

USB (AUTO)

Operations are synchronized to the USB Clock received via USB. However, operations are automatically synchronized to this unit’s internal clock if the GX-10 is unable to receive the external Clock.

CLOCK OUT

Specifies whether MIDI clock will be output from the GX-10.

OFF

MIDI clock is not output.

ON

MIDI clock is output.

Specifies the controller number when transmitting pedal operations as control change messages.

É CC#

Ç CC#

EXP1 SW CC#

CTL1 CC#

CTL2 CC#

CTL3 CC#

EXP1 CC#

EXP2 CC#

OFF

Control Change messages are not output.

CC#1–CC#31,

CC#64–CC#95

Pedal operations are transmitted using the specified controller number.