VCO-1/VCO-2 section
This section is used to select the waveforms that determine the character of the sound, and to set the pitch.
MEMO
If you’re viewing this content on your smartphone, we recommend that you turn your smartphone on its side for landscape mode.
VCO-1
Controller (Parameter name) | Value | Explanation |
|---|---|---|
[CROSS MOD] slider (Cross Mod) | 0–127 | Uses the VCO-2 waveform to change the frequency of VCO-1. Larger values give VCO-1 a more complex sound, which lets you create metallic sounds or sound effects. |
[RANGE] knob (VCO-1 Range) | 32', 16', 8', 4', 2', 1' | Sets the octave for VCO-1. |
[WAVEFORM] knob (VCO-1 Waveform) | Selects the fundamental waveform to use for VCO-1. | |
SINE | ||
TRI | ||
SAW | ||
PW | ||
SQR | ||
NOISE | ||
VCO-2
Controller (Parameter name) | Value | Explanation |
|---|---|---|
[RANGE] switch (VCO-2 Mode) | NORMAL, LO FREQ | When this is set to LO FREQ, VCO-2 operates as an LFO. |
[RANGE] knob (VCO-2 Range) | 0–127 (when VCO-2 Mode is LO FREQ) | Sets the pitch of VCO-2. |
-12–+24 (when VCO-2 Mode is NORMAL) | ||
[SYNC] switch (Sync Switch) | OFF, ON | When set to “ON”, this creates a complex waveform by forcibly restarting VCO-2 so that it syncs with the cycle of VCO-1 (oscillator sync). |
[FINE TUNE] knob (VCO-2 Fine Tune) | -50–+50 | Fine-tunes the pitch of VCO-2. |
[WAVEFORM] knob (VCO-2 Waveform) | Selects the fundamental waveform to use for VCO-2. | |
SINE | ||
TRI | ||
SAW | ||
PW | ||
SQR | ||
NOISE | ||
VCO-1/VCO-2
Controller (Parameter) | Value | Explanation |
|---|---|---|
[MIX] knob (Mix) | 255:0–0:255 (VCO-1:VCO-2) | Adjusts the volume balance between VCO-1 and VCO-2. |