2Tap Pan Delay
MEMO
- You can also press a corresponding step button to select the parameter items.
- If you’re viewing this content on your smartphone, we recommend that you turn your smartphone on its side for landscape mode.
Step buttons | Parameter | Value | Explanation |
|---|---|---|---|
[1] | tyPe | dLy2 | The delay sound is heard both at the left and at the right. |
[2] | Sľ | Off, On | Turns the effect on/off. |
[3] | Sync | Off, On | When this is “ON”, the effect synchronizes with the tempo of the rhythm. |
[4] | TiNE | 1–2600 (ms) | Delay time from when the direct sound until the delay sound is heard |
[5] | notE | ||
[6] | Fb | -98–98 (%) | Proportion of the delay sound that is fed back into the effect (negative values invert the phase) |
[7] | H.dNP | 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000 (Hz), byPS | Center frequency at which the high frequencies of the delay sound fed back to the input are cut (byPS: frequencies are not cut)
|
[8] | PAn1 | L 64–r 63 | Delay 1 pan |
[9] | PAn2 | L 64–r 63 | Delay 2 pan |
[10] | LEU1 | 0–127 | Delay 1 volume |
[11] | LEU2 | 0–127 | Delay 2 volume |
[12] | EQ.Lo | -15–15 (dB) | Amount of low range boost/cut |
[13] | EQ.Hi | -15–15 (dB) | Amount of high range boost/cut |
[14] | bAL | Volume balance between the effect sound and dry (original) sound | |
0–100 | 0 (Effect sound = 0: dry sound = 100) 100 (Effect sound = 100: dry sound = 0) | ||
[15] | LEU | 0–127 | Output level |