Reverb parameters
MEMO
- You can also press a corresponding step button to select the parameter items.
- If you’re viewing this content on your smartphone, we recommend that you turn your smartphone on its side for landscape mode.
Step buttons | Parameter | Value | Explanation |
|---|---|---|---|
[1] | SEnd | 0–127 | Sets the amount of reverb for the selected part. If you don’t want to add the reverb effect, set this to 0. |
[2] | NodE | Std, SHIN | Select the reverb mode. Std: default SHIN: shimmer reverb |
When Mode is Std (default)
Step buttons | Parameter | Value | Explanation |
|---|---|---|---|
[3] | typE | roN.1, roN.2, HAL.1, HAL.2, PLAt | Selects the type of reverb. |
[4] | P.dLy | 0–100 | Sets the time from when the direct sound is heard until the reverb sound is heard. |
[5] | tiNE | 1–100 | Sets the decay length of the reverb sound. |
[6] | LEU | 0–127 | Adjusts the output level of the sound with reverb applied. |
When Mode is SHIN (shimmer reverb)
Step buttons | Parameter | Value | Explanation |
|---|---|---|---|
[3] | L.dNP | -50–50 | Adjusts how much to attenuate the low-frequency portion of the reverb. |
[4] | H.dNP | -50–50 | Adjusts how much to attenuate the high-frequency portion of the reverb. |
[5] | tiNE | 0.1–10.0 (sec) | Adjusts the decay length of the reverb sound. |
[6] | dnSt | 1–10 | Adjusts the density of the reverb sound. |
[7] | P.dLy | 0–100 (msec) | Adjusts how long it takes until the reverb sound is heard, after the direct sound plays. |
[8] | Nd.rt | 0–100 | Adjusts the speed at which the reverb sound is modulated. |
[9] | Nd.dP | 0–100 | Adjusts the depth to which the reverb sound is modulated. |
[10] | PCH1 | -24–24 | Adjusts the amount of pitch shift applied for pitch shift 1 (in semitones). |
[11] | PCH2 | -24–24 | Adjusts the amount of pitch shift applied for pitch shift 2 (in semitones). |
[12] | Fb1 | -98–98 (%) | Adjusts the ratio of the pitch shift 1 sound that is fed back into the input. Negative (-) settings invert the phase. |
[13] | Fb2 | -98–98 (%) | Adjusts the proportion of the delay sound that is fed back into pitch shift 2. Negative (-) settings invert the phase. |
[14] | LEU1 | 0–100 | Adjusts the volume of pitch shift 1. |
[15] | LEU2 | 0–100 | Adjusts the volume of pitch shift 2. |
[16] | LEU | 0–127 | Adjusts the output level of the sound with reverb applied. |