Delay parameters
MEMO
- You can also press a corresponding step button to select the parameter items.
- If you’re viewing this content on your smartphone, we recommend that you turn your smartphone on its side for landscape mode.
Step buttons | Parameter | Value | Explanation |
|---|---|---|---|
[1] | SEnd | 0–127 | Sets the amount of delay for the selected part. If you don’t want to add the delay effect, set this to 0. |
[2] | Sync | OFF, On | If this is “ON”, the delay synchronizes with the tempo. |
[3] | tiNE | 1–1300 (msec) | Delay time from when the original sound is heard until the second delay sound |
[4] | notE | ||
[5] | Fb | -98–98 (%) | Proportion of the delay sound that is fed back into the effect (negative values invert the phase) |
[6] | H.dNP | 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000 (Hz), byPS | Center frequency from which the high-end frequencies of the delay sound fed back to the input are cut (byPS: no frequencies are cut) |
[7] | PAn1 | L64–r63 | Delay 1 pan |
[8] | PAn2 | L64–r63 | Delay 2 pan |
[9] | LEU1 | 0–127 | Delay 1 volume |
[10] | LEU2 | 0–127 | Delay 2 volume |
[11] | LEU | 0–127 | Output level |
[12] | r.Snd | 0–127 | Specifies the send level to reverb. |