Configuring drawing

Drawing lets you freely draw the waveform to be used by the oscillator. The waveform you create plays as a single-cycle waveform. The waveform is divided into a maximum of 32 ranges, and you can specify the value for each range. When the waveform is played back, the values for each range are connected together in a continuous way to let you freely create and play the waveform.

MEMO

If you’re viewing this content on your smartphone, we recommend that you turn your smartphone on its side for landscape mode.


Step buttons	Item	Value	Explanation
[1]	Sľ (Drawing Switch)	OFF, On	Drawing is enabled when this is “ON”.
[2]	NOPH (Morph Rough)	0–127	Sets how rough the sound quality is. This is enabled when Drawing Switch is “ON”.
[3]	1.16	-	Sets the drawing waveform data.
[4]	17.32	-	Sets the drawing waveform data.
[5]	tooL	-	Edits the waveform data that you set by drawing.

3:1.16


Step buttons	Item (Parameter name)	Value	Explanation
[1]–[16]	ľd.1–ľd.16 (Wave Data 1-16)	-72–72	Sets the waveform data for Wave Data 1–16. This is enabled when Drawing Switch is “ON”.

4:17.32


Step buttons	Item (Parameter name)	Value	Explanation
[1]–[16]	ľd.17–ľd.32 (Wave Data 17-32)	-72–72	Sets the waveform data for Wave Data 17–32. This is enabled when Drawing Switch is “ON”.

5: tooL


Step buttons	Item (Parameter name)	Value	Explanation
[1]	ForN (Drawing Tool Form 1)	0–127	Morphs between the waveforms as follows: Sine (0)–Triangle (42)–Saw (84)–Square (127). This is enabled when Drawing Switch is “ON”.
[2]	Nod (Drawing Tool Form 2)	0–127	Morphs between a sine wave (0) and a metallic sound (127). This is enabled when Drawing Switch is “ON”.
[3]	SynC (Drawing Tool Sync)	0–127	Narrows the width of the waveform that’s currently set, and repeats it. This is enabled when Drawing Switch is “ON”.
[4]	ľidt (Drawing Tool Width)	0–127	Narrows the width of the waveform that’s currently set. This is enabled when Drawing Switch is “ON”.
[5]	ALPH (Drawing Tool AM Depth)	0–127	Deforms the currently set waveform by applying a comb filter to thin out the data. This is enabled when Drawing Switch is “ON”.
[6]	ľrit (Drawing Tool Exec)	-	Pressing the [VALUE] knob applies the changes you made using the Drawing Tool to the waveform. This is enabled when Drawing Switch is “ON”.