Restoring the factory settings (Factory Reset)

Here’s how to return the P-6 to its factory-set state.

NOTE

When you perform a factory reset, all of the sample data and patterns stored in the P-6 are deleted.

If you have any essential data that’s still stored on this unit, back up the data before doing the factory reset.

For details on how to back up the data, refer to “Backing up samples to your computer (export)” and “Backing up the patterns to your computer”.

  1. While holding down the [KYBD] button, turn on the power.
  2. “FACt” is shown, and the [GRANULAR] pad blinks.
  3. To cancel the factory reset, turn off the power.
  4. Press the [GRANULAR] pad.
  5. This executes the factory reset.
  6. Once “donE” is displayed and all buttons are blinking, turn the power of the P-6 off and then on again.

MEMO

You can’t perform a factory reset to restore the internal sample data and patterns that came with the unit when it was shipped from the factory.

If you wish to restore that sample data, you can download it from the Roland website.

https://www.roland.com/support/