Deleting knob operations recorded in a pattern

Here’s how to delete the knob operations recorded using the steps in “Recording the knob motions”.

  1. Press the [OCT-] (MOTION) button while holding down the [SHIFT] button.
  2. “CLr.÷” blinks in the display.
  3. Press the [C´] (ENTER) button.
  4. All of the knob operation data in the pattern is deleted.
  5. To cancel the operation, press the [C] (EXIT) button.

MEMO

You can also specify a certain type of motion that you want to delete.

  1. After step 1, turn the knob ([PITCH]–[LEVEL] knobs) corresponding to the motion parameter you want to delete.
  2. If the motion you specified is recorded in the pattern, “CLr” is shown, and the specified motions are deleted.
  3. If the motion you specified isn’t in the pattern, “nonE” is shown.
  4. Press the [C] (EXIT) button.