Restoring the patterns (Restore)

You can restore the pattern files you saved on your computer to the P-6.

  1. Connect your computer to the P-6’s USB port via USB cable.
  2. While holding down the [ó] button, turn on the power.
  3. Open the “P-6” drive on your computer.
  4. Copy the pattern files (P6_PTN1-01.PRM – P6_PTN4-16.PRM) saved on your computer to the “RESTORE” folder of the “P-6” drive.
  5. Once copying is finished, eject the “P-6” drive from your computer.
  6. Press the [KYBD] button.
  7. This restores the patterns.
  8. If there are many patterns to restore, the operation may take around five minutes.
  9. The step buttons light up to show the progress.
  10. Once you see the message “donE”, turn off the P-6.