Loading samples (Import)

You can import samples into the P-6.

  1. Connect your computer to the P-6’s USB port via USB cable.
  2. While holding down the [SAMPLING] button, turn on the power.
  3. Open the “P-6” drive on your computer.
  4. Copy the sample files you want to import into the pad folders (PAD_1–PAD_6) in the “IMPORT” folder on the “P-6” drive.
  6. The specifications for the sample files you can import are as follows.
  7. Cell_vertical_blue

    Item

    Required specifications for samples to import

    Sample rate

    Max. 96 kHz

    Bit rate

    8, 16, 24, 32-bit linear

  8. MEMO

    1. The available sample time for samples to import into the P-6 varies with the sample rate and bit rate.
      Refer to “Maximum sample time” for details.
    2. When you import the samples that were exported from the P-6, we recommend that you also copy the sample pad setting data (the PRM files that are output during export) to the pad folders.
  9. Once copying is finished, eject the “P-6” drive from your computer.
  10. Press the [KYBD] button.
  11. The sample is imported.

  12. MEMO

    It may take some time to load many samples.

    The step buttons light up to show the progress.

    Data that exceeds the size of the sample pads is truncated.

  13. Once you see the message “donE”, turn off the P-6.