Copying a sequence

This shows how to copy the sequence (performance data) from a selected pad, out of the data that’s input in the pattern sequencer.

  1. Select the pattern that contains the sequence you want to copy.

  2. MEMO

    For details on how to select the pattern, refer to “Selecting a pattern”.

  3. Press a sample pad or the [GRANULAR] pad to select the pad’s sequence that you want to copy.
  4. Press the [ø] button while holding down the [SHIFT] button.
  5. Use the [TEMPO/VALUE] knob to select “PArt”.
  6. Press the [C´] (ENTER) button.
  7. “COPY” (Copy) blinks in the display.
  8. The [C´] (ENTER) button rapidly blinks, and the sequence is copied to the temporary memory of the P-6.

  9. MEMO

    To delete the sequence you copied to the temporary of the P-6, press the [C´] (ENTER) button while holding down the [SHIFT] button.

    “CLr” is shown on the display.

  10. Press the [PATTERN] button, and then use the [TEMPO/VALUE] knob to select the copy destination pattern for the sequence.
  11. Press the [ø] button while holding down the [SHIFT] button.

  12. MEMO

    You don’t need to perform steps 6 and 7 if the copy source and destination pattern numbers are the same.

  13. Press a sample pad or the [GRANULAR] pad to select the pad where you wish to use the sequence that you copied.
  14. Press the [C´] (ENTER) button.
  15. “PStE” (Paste) blinks in the display.
  16. The sequence stored in the temporary memory of the P-6 is now pasted into (overwrites) the specified pad.
  17. The temporary memory is then cleared, and the [C´] (ENTER) button blinks slowly.