Inserting an empty step

This shows how to insert an empty step at the location of the current step.

  1. Press the [ó] button.
  2. Now you can edit the notes in the steps.
  3. “St.” and the step number to be edited are shown in the display.
  4. Use the [TEMPO/VALUE] knob to select the insert destination step.
  5. Press the [OCT+] button while holding down the [KYBD] button.
  6. Use the [TEMPO/VALUE] knob to select “Insr” (Insert).
  7. Press the [C´] (ENTER) button.
  8. “donE” is shown, and an empty step is inserted at the current step.

MEMO

  1. When the step is inserted, all other steps that come afterward are shifted one step later, and the LAST STEP value increases by one.
  2. When the LAST STEP setting is “64”, you can’t insert any steps.
    When inserting a step, set the LAST STEP to a value smaller than 64.
    Refer to “Setting the pattern length” for details.