SAMPLE EDIT (MIXER) settings
These are the parameters (items to set) you see when you press the [A] (MIXER) button while holding down the [SHIFT] button.
MEMO
If you’re viewing this content on your smartphone, we recommend that you turn your smartphone on its side for landscape mode.
Parameter | Display | Controller | Value | Explanation |
|---|---|---|---|---|
Level | LEvL | [LEVEL] knob (*1, *3) | 0–127 | Sets the volume level. MEMO
|
Level Jitter (*2) | LEv.J |
| 0–100 | Randomly alters the volume for each grain. Larger values produce more variances in volume. |
Auto Pan | A.PAn |
| This alters the pan (stereo position) for each note that sounds. | |
OFF | The pan position remains the same. | |||
ALt (Alternate) (*2) | The pan position alternates between left and right with each note that sounds. | |||
Sľng (Swing) (*2) | The pan position moves from left to right and back with each note that sounds. | |||
rnd (Random) | The pan is randomly changed for each note that sounds. | |||
Pan | PAn | [PITCH] knob (*3) | L64–C–r63 | Sets the pan position. MEMO This is enabled when the Auto Pan parameter is “OFF”. |
Output Bus Select | OUt.b |
| This specifies the output bus to use. MEMO You can also change this setting as described in “Switching between buses for sending sound”. | |
bUS.A | Outputs to BUS A. | |||
bUS.b | Outputs to BUS B. | |||
EFCt | Outputs to BUS EFFECT. | |||
Send Delay | Snd.d | [START] knob (*3) | 0–255 | Specifies how much signal is sent to the Delay send effect. |
Send Reverb | Snd.r | [END] knob (*3) | 0–255 | Specifies the how much signal is sent to the Reverb send effect. |
- This is enabled on the top screen (the tempo display you see right after the power is turned on) or on the SAMPLE EDIT (MIXER) screen.
- This is enabled for the [GRANULAR] pad.
- This is enabled on the SAMPLE EDIT (MIXER) screen.