BF-2

In production for over 20 years, the original BF-2 hardware featured a unique analog design based around a single BBD chip. Via its four-knob interface, this versatile effect produces an array of warm modulated tones, from metallic and phase-shifted textures to soft chorus and wavering vibrato.

 

Page

Parameter

Value

Explanation

1

MANUAL

0–100

Adjusts the delay time (audio latency).

DEPTH

0–100

Adjusts the sweep width, based on the delay time set in the manual parameter.

RATE

0–100, BPM

Adjusts the sweep cycle (rate).

When this is set to “BPM”, the LED indicates the tempo.

2

RES

0–100

Adjusts the amount of feedback.

BPM

40–250

Adjusts the tempo if “BPM” is selected for RATE.

This is only shown when RATE is set to “BPM”.

–

–

 

3

CTL1 TARGET

OFF, MANUAL, DEPTH, RATE, RES, TAP

Selects the parameter to control from a footswitch connected to CTL1.

  • Tap operations are disabled when there is an external MIDI input.

CTL1 MODE

MOMENT, TOGGLE

Selects the operation mode for the footswitch that’s connected to CTL1.

  • This is not shown when CTL1 TARGET is set to “TAP”.

CTL1 VALUE

0–100

Sets the value for the parameter that’s controlled from a footswitch connected to CTL1.

  • This is not shown when CTL1 TARGET is set to “TAP”.

4

CTL2 TARGET

OFF, MANUAL, DEPTH, RATE, RES, TAP

Selects the parameter to control from a footswitch connected to CTL2.

  • Tap operations are disabled when there is an external MIDI input.

CTL2 MODE

MOMENT, TOGGLE

Selects the operation mode for the footswitch connected to CTL2.

  • This is not shown when CTL2 TARGET is set to “TAP”.

CTL2 VALUE

0–100

Selects the value for the parameter that’s controlled from a footswitch connected to CTL2.

  • This is not shown when CTL2 TARGET is set to “TAP”.

5

EXP TARGET

OFF, MANUAL, DEPTH, RATE, RES, BPM

Selects the parameter controlled by an external expression pedal connected to the EXP jack.

EXP MIN

0–100, 40–250

Sets the minimum value for the parameter controlled by an expression pedal connected to the EXP jack.

EXP MAX

0–100, 40–250

Sets the maximum value for the parameter controlled by an expression pedal connected to the EXP jack.

6

PEDAL MODE

MOMENT, TOGGLE

Selects the operation mode for the pedal switch on the PX-1.

When PEDAL MODE is set to “TOGGLE”, you can long-press the pedal switch to use tap input.

ACTION

OFF Ó ON, ON Ó OFF

Sets how the pedal switch on this unit operates when PEDAL MODE is set to “MOMENT”.

–

–