Selecting how the effect sound is output (OUTPUT MODE)

By changing the output mode, you can change the way the effect sound is output.

Follow the steps below to change the output mode.

  1. Turn off the RT-2 (unplug the cable from the INPUT A (MONO) jack).
  2. Turn the [FAST] knob to the maximum (MAX) setting.
  3. Turn all other knobs besides the [FAST] knob to the minimum (MIN) setting.
  4. Set the [MODE] switch to the “I” position.
  6. Turn on the power by connecting a plug to the INPUT A (MONO) jack while holding down the pedal switch.
  7. The CHECK indicator blinks, and the unit enters settings mode.
  8. Set the [MODE] switch to the position that corresponds to the desired output mode.

  9. [MODE] switch position

    CHECK indicator color

    Explanation

    I

    Color of current setting

    Shows the current output mode.

    The output mode is not changed.

    For an explanation of the colors that correspond to the current output mode, see the “red” and “green” descriptions below.

    II

    Red

    Stereo output: (factory setting)

    The OUTPUT A (MONO) and OUTPUT B jacks are used to output individual effects, creating a stereo effect.

    III

    Green

    Effect (wet) sound + direct (dry) sound

    The effect (wet) sound is output from the OUTPUT A (MONO) jack, and the direct (dry) sound is output from the OUTPUT B jack.

  10. Press the pedal switch.
  11. The CHECK indicator rapidly blinks red, and the output mode setting is stored in memory.
  12. The device can be used normally after around 2–3 seconds.