Configuring the noise suppressor

The RT-2 has a built-in noise suppressor that can cut unwanted noise.

Follow the steps below to change how the noise suppressor works.

  1. Turn off the RT-2 (unplug the cable from the INPUT A (MONO) jack).
  2. Turn the [SLOW] knob to the maximum (MAX) setting.
  3. Turn all other knobs besides the [SLOW] knob to the minimum (MIN) setting.
  4. Set the [MODE] switch to the “III” position.
  6. Turn on the power by connecting a plug to the INPUT A (MONO) jack while holding down the pedal switch.
  7. The CHECK indicator blinks, and the unit enters settings mode.
  8. Set the [MODE] switch to the position that corresponds to the desired noise suppressor effect.

  9. [MODE] switch position

    CHECK indicator color

    Explanation

    I

    Red

    Switches the noise suppressor off (factory setting).

    II

    Green

    This noise suppressor setting is effective for low noise levels.

    III

    Orange

    This noise suppressor setting is effective for high noise levels.

  10. With this setting, you can monitor the sound of the effect. This lets you configure the noise suppressor while checking its effectiveness.
  11. Press the pedal switch.
  12. The CHECK indicator rapidly blinks red, and the noise suppressor setting is stored in memory.
  13. The device can be used normally after around 2–3 seconds.