Auto Wah
Cyclically controls a filter to create cyclic change in timbre.
Parameter | Value | Explanation |
|---|---|---|
Mode | LPF, BPF | Filter type LPF: The wah effect will be applied over a wide frequency range. BPF: The wah effect will be applied over a narrow frequency range. |
Manual | 0–127 | Center frequency at which the wah effect is applied |
Peak | 0–127 | Width of the frequency region at which the wah effect is applied. Increasing this value will make the frequency region narrower. |
Sens | 0–127 | Sensitivity with which the filter is modified |
Polarity | UP, DOWN | Direction in which the filter will move UP: The filter will change toward a higher frequency. DOWN: The filter will change toward a lower frequency. |
Rate Sync | OFF, ON | If this is ON, the rate synchronizes with the tempo of the rhythm. |
Rate | 0.05–10.00 [Hz] | Frequency of modulation |
Rate Note | ||
Depth | 0–127 | Depth at which the wah effect is modulated |
Phase | 0–180 [deg] | Adjusts the degree of phase shift of the left and right sounds when the wah effect is applied. |
Low Gain | -15–+15 [dB] | Amount of boost/cut for the low-frequency range |
High Gain | -15–+15 [dB] | Amount of boost/cut for the high-frequency range |
Level | 0–127 | Output Level |