Flanger
This is a stereo flanger (The LFO has the same phase for left and right.).
It produces a metallic resonance that rises and falls like a jet airplane taking off or landing.
A filter is provided so that you can adjust the timbre of the flanged sound.
Parameter | Value | Explanation |
|---|---|---|
Type | OFF, LPF, HPF | Filter type OFF: No filter is used LPF: Cuts the frequency range above the Cutoff Freq HPF: Cuts the frequency range below the Cutoff Freq |
Cutoff | 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000 [Hz] | Basic frequency of the filter |
Pre Delay | 0.0–100 [ms] | Delay time from the direct sound until the flanger sound is heard |
Rate Sync | OFF, ON | If this is ON, the rate synchronizes with the tempo of the rhythm. |
Rate | 0.05–10.00 [Hz] | Frequency of modulation |
Rate Note | ||
Depth | 0–127 | Depth of modulation |
Phase | 0–180 [deg] | Spatial spread of the sound |
Feedback | -98–+98 [%] | Adjusts the proportion of the flanger sound that is fed back into the effect. Negative (-) settings will invert the phase. |
Low Gain | -15–+15 [dB] | Amount of boost/cut for the low-frequency range |
High Gain | -15–+15 [dB] | Amount of boost/cut for the high-frequency range |
Balance | D100:0W–D0:100W | Volume balance between the direct sound (D) and the flanger sound (W) |
Level | 0–127 | Output Level |