Editing a sample in DJ mode

You can edit the samples that are used in DJ mode.

  1. Press the [VALUE] knob.
  2. A menu appears.
  4. Use the [VALUE] knob to select “CH1 EDIT” or “CH2 EDIT,” and press the [VALUE] knob.
  5. The sample edit screen appears. The editing method is the same as for sample edit in sample mode.

Controller

Operation

[CTRL 1] knob

Moves the start point.

[CTRL 2] knob (when the loop is on)

Moves the loop point.

[CTRL 3] knob

Moves the end point.

[SHIFT] button + [CTRL] knob (turn)

Zooms the area around each point in/out.

[VALUE] knob (turn)

Zooms the area in/out around each point you just manipulated.

[VALUE] knob (press)

You can use a numerical value to set the position of each point.

Use the [VALUE] knob to select the point to set, and press pads [1]–[10] to input the position (press pad [10] to input a “0”).

To confirm the inputted position, press the [VALUE] knob.

[SHIFT] button + [VALUE] knob (turn)

Adjusts the volume of the channel.

[DEL] button

Initializes the start and end point positions.

  • When a confirmation message appears, use the [VALUE] knob to select “OK,” and press the [VALUE] knob.

[REMAIN] button

On: Prevents the start point from being moved beyond the loop point or the end point.

Off: When the start point moves beyond the loop point or the end point, this moves the loop point or the end point as well.

[ROLL] button

While this button is pressed, you can preview the sound several seconds before the end point.