Sending the audio input from the INPUT jack to a bus

You can set the bus to which the playback audio signals coming into the INPUT jack are sent (meaning which effects are used).

  1. Hold down the [SHIFT] button and press the pad [13].
  2. The UTILITY MENU screen appears.
  4. Use the [VALUE] knob to select “EFX SET” and press the [VALUE] knob.
  5. The effect setting screen appears.

  6. MEMO

    From the top screen, you can also make this screen appear by pressing pad [16] while holding down the [SHIFT] button.

  7. Turn the [CTRL 3] knob to select “OTHER”.
  9. Use the [VALUE] knob to move the cursor to “Input Bus” and press the [VALUE] knob.
  10. The displayed value is highlighted, and you can now edit the Input Bus.

  11. Value

    Explanation

    DRY

    The signal is not sent to BUS 1, BUS 2 (the BUS 1 and BUS 2 effects are not used).

    BUS1, BUS2

    The signal is sent to BUS 1 or BUS 2. The effects set for BUS 1 and BUS 2 are used.

  12. Use the [VALUE] knob to select the bus, and press the [VALUE] knob.
  13. This confirms the bus to which the input audio is sent.
  14. To finish making settings, press the [EXIT] button.