Configuring the driver

This shows how to configure the USB driver for V-STAGE.

Changes to the USB driver settings take effect when the unit restarts.

Press the [MENU] button to select System Ó General.
Use the [SELECT] knob to select “USB Driver”, and press the [SELECT] knob.
Use the [SELECT] knob to specify “VENDOR”.
Press the [WRITE] button.
A confirmation message appears.
If you decide to cancel, press the [EXIT] button.
Use the [SELECT] knob to select “OK”, and press the [SELECT] knob.
Turn the power of the V-STAGE off and then on again.