Operating MainStage
When the DAW control function is turned on, you can use the buttons on the V-STAGE to operate MainStage.
|
Button |
Function |
|---|---|
|
[SHIFT] button + [ASSIGN] button |
Switch between modes Switch the V-STAGE to DAW CTRL mode. |
|
[EXIT] button |
Switch between modes Switches the V-STAGE to normal mode. |
|
[â] button |
Next Set Recalls the next set. |
|
[ã] button |
Previous Set Recalls the previous set. |
|
[INC] button |
Next Patch Recalls the next patch. |
|
[DEC] button |
Previous Patch Recalls the previous patch. |
MEMO
- Changes to the Set name, Track name, Smart Control parameter name and so forth in MainStage may not be immediately visible on the V-STAGE’s screen.
- The Smart Control parameter values change according to the settings in MainStage. These values do not necessarily change within the minimum to maximum value range based only on the operations performed with the V-STAGE. Make sure to configure the settings on the MainStage to match the necessary range.
- If you’re having a hard time controlling this, select the “Assignments & Mappings” tab in edit mode and check whether the ports are set as shown below.
- Assignment: V-STAGE
Ó Pitch Bend, Expression, Sustain, Modulation - Assignment: V-STAGE DAW CTRL
Ó Volume, Smart Knob - Reassign the control if it is already assigned as another control in the MainStage project.
- When you turn the DAW CTRL function off, the knob display returns to the previously selected function. This function cannot be configured when the DAW CTRL function is off.