MIDI
These parameters configure the MIDI settings.
Parameter | Explanation |
|---|---|
Device ID | When transmitting and receiving system exclusive messages, use this parameter to match the device ID numbers of both devices. |
Scene Control Ch | Sets the MIDI channel used for controlling scenes. |
USB-MIDI Thru | Specifies whether MIDI signals received at the USB COMPUTER port/MIDI IN connector are retransmitted without change from the MIDI OUT 2/THRU connector and the USB COMPUTER port (ON), or are not retransmitted (OFF). |
Soft Through | Specifies whether MIDI signals received at the MIDI IN connector are retransmitted as-is from the MIDI OUT 2/THRU connector (ON), or are not retransmitted (OFF). |
Remote Keyboard Sw | Set this to “ON” if you want to use an external MIDI keyboard instead of the V-STAGE’s keyboard. In this case, the MIDI transmit channel of the external MIDI keyboard does not matter. Normally, this is set to “OFF”. |
Tx Program Change | Sets whether to transmit a program change message (ON) or not (OFF) when you switch the scene or tone. |
Tx Bank Select | Sets whether to transmit a bank select message (ON) or not (OFF) when you switch the scene or tone. |
Tx Active Sens | Sets whether active sensing messages are transmitted (ON) or not (OFF). |
Tx Edit Data | Specifies whether changes you make to a scene are transmitted as system exclusive messages (ON) or not (OFF). |
Rx Program Change | Specifies whether program change messages are received (ON) or not (OFF). |
Rx Exclusive | Specifies whether system exclusive messages are received (ON) or (OFF). |