Pairing the DH-10 and WT-10

This shows you how to pair a WT-10 to which a cymbal is connected, with a DH-10 connected to the V31.

  1. On the TRIGGER - ADVANCED screen, press the [F4] (DrumLink) button.
  2. Press the [F1] (HUB) button.
  3. The DrumLink - HUB screen appears.
  4. Press the [F5] (PAIRING) button.
  5. Pairing mode turns on.

  7. MEMO

    Once it is turned on, the pairing mode turns off after 15 seconds.

  8. Strike the cymbal once.

  9. MEMO

    When pairing, use a stick and strike the drum or cymbal fairly hard. Also, when pairing with a cymbal, strike the edge to make pairing easier, as the sensitivity is greater.

  11. Pairing begins.
  12. The pad image on the right side of the DrumLink - HUB screen (default settings: PDX-8 drum pad) is shown when the V31 is paired with the pad (cymbal).
  14. To access the pad settings screen after pairing, press the [EXIT] button and then one of the [F2] (BASIC)–[F4] (OPT/ADV) buttons.

NOTE

The parameters for each pad are not stored on the V31, but are stored in the WT-10 (Wireless Trigger Adapter). Note that just changing a parameter does not apply the setting to the WT-10. You must strike the applicable pad to apply the setting.

MEMO

  1. Once paired, the pairing information for each WT-10 (Wireless Trigger Adapter) is saved on the DH-10 (DrumLink Hub). The units automatically pair when you restart the V31 or connect the DrumLink™ hub to a different V31, so there’s no need to pair manually.
  2. Although pairing is not necessary after restarting this unit, you must strike the pad you want to set once to make it show up on the pad settings screen.
  3. The V31 supports connections of up to 12 pads.