Specify the pad type

You can specify the type of pad (trigger type) used by the trigger bank for each trigger input.

Trigger type

The trigger type is a collection of various trigger parameters, adjusted to values that are appropriate for each pad. In order to make the optimal settings for the pad that’s being used for each trigger input, specify the model (type) of pad that’s connected.

Trigger bank

A trigger bank contains an entire set of settings for ten triggers.

Press the [SETUP] button.
Use the cursor buttons to select “TRIGGER”, and press the [ENTER] button.
Press the [F1] (BANK) button.
The TRIGGER - BANK screen appears.
Use the [-] [+] buttons or the dial to specify the trigger bank.
Select the pad to configure.
Ø “Selecting the pad to set”
Use the [-] [+] buttons or the dial to specify the trigger type.

You can’t change the trigger type of a trigger input that’s assigned to a pad that supports a digital connection.

MEMO

You can press the [F6] (DEFAULT) button while holding down the [SHIFT] button to restore the selected trigger bank to its factory settings.
When you specify the trigger type, the trigger parameters (with the exception of certain parameters such as cross-stick cancel) are set to optimal values. These values are only general guidelines; you can make fine adjustments as appropriate according to how you attach the pad and how you use it.
For details, refer to “Data List” (Roland website).
With the Global Sens setting, you can adjust the sensitivity of all the pads at once. For a broader range of dynamic control, select “LOW”. To play with a light touch, select “HIGH”. This setting is enabled for each trigger bank.