Wired LAN connection

Connect the iPad directly to your video switcher using an Ethernet adaptor and LAN cable.

  1. Connect the DIRECT STREAM port or the LAN CONTROL connector of the video switcher to your iPad via Ethernet adaptor and LAN cable.

  2. Communication standards

    Connector/port

    CONTROL port (LAN)

    Protocol

    TCP

    Port number

    8023

  3. Turn on the video switcher.
  4. Press the [MENU] button Ó “Network” Ó “LAN Setup” Ó set “Configure” to “Manual”, and press the [VALUE] knob.
  5. Use the [VALUE] knob to select “Network Password”, and press the [VALUE] knob.
  6. The Network Password screen appears.
  7. Set a network password.
  8. The password you set here is required when accessing the video switcher from VenuSet.
  9. Use the [VALUE] knob to select “Network Information”, and press the [VALUE] knob.
  10. The Network Information screen appears.
  11. When “Connected” is shown in “Link Status”, you’re finished with the video switcher connection settings.
  12. Press the [MENU] button to close the menu.

 

  1. Connect the Ethernet adaptor to the iPad.
    1. Tap “Ethernet” in the settings menu and open “USB 10/100/1000 LAN”.
    2. Tap “Configure IP”.
    4. Select "Manual", set the values of the following settings and tap "Save".

  3. Input field

    Explanation

    IP address

    Set a value that does not overlap with the IP address of any other devices connected to the network.

    The value should be appropriate for the network to which you are connecting.

    Subnet mask

    Configures the subnet mask.

    The value should be appropriate for the network to which you are connecting.

  4. Launch VenuSet.
  5. Tap the [status icon].
  7. * If the app is already connected to a different device or using a different connection method, the status icon may show “Online”.
  8. Tap the [LAN] button.
  10. Input the “IP Address” and “Network Password” fields, and tap the [Connect] button.

  12. Input field

    Explanation

    IP Address

    Input the IP address of the video switcher.

    You can check this information by pressing the video switcher’s [MENU] button and selecting “Network” Ó “Network Information”.

    Network Password

    Input the network password set on the video switcher.

  13. When the status icon changes to “Online (LAN)”, the connection is established.