Replacing the battery

Batteries should always be installed or replaced before connecting any other devices. This way, you can prevent malfunction and damage.

  1. Hold down the pedal and loosen the thumbscrew, then open the pedal upward.
  2. You don’t need to take the thumbscrew out completely to open the pedal.
  3. Remove the old battery from the battery housing, and remove the battery snap connected to it.
  4. Connect the battery snap to the new battery, and place the battery inside the battery housing.
  5. Be sure to carefully observe the battery’s polarity (+ versus -).
  6. Slip the coil spring onto the spring base on the back of the pedal, and then close the pedal.
  7. Carefully avoid getting the snap cord caught in the pedal, coil spring, and battery housing.
  8. Finally, hold down the pedal while tightening the thumbscrew into the guide bush hole.