Introduction

The JUPITER-08 is a sound module that can be used along with the K-25m keyboard unit.

This unit operates on batteries or USB bus power, and features a built-in speaker to produce sound.

Using this unit along with the K-25m keyboard unit

By using this unit along with the K-25m, you can play notes with the keyboard, input patterns using the keyboard and so forth.

Refer to the K-25m Owner’s Manual for how to attach, remove and adjust the angle of this unit.

Using this unit along with the Boutique Dock DK-01 (sold separately)

When using this unit along with the DK-01, you can adjust its angle during setup.

Refer to the DK-01 Owner’s Manual for how to attach, remove and adjust the angle of this unit.

Triggering this unit with MIDI and USB signals

You can play the JUPITER-08 by sending it MIDI or USB signals. For details, refer to “Rear panel” and “Configuring the MIDI settings”.

• This unit operates on batteries or USB bus power. If you are using batteries, insert four AA batteries in the correct orientation.
• If you handle the batteries improperly, you risk explosion and fluid leakage. Make sure that you carefully observe all of the items related to batteries that are listed in “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (the leaflet “USING THE UNIT SAFELY”).
• “bat.L” is shown when the batteries are nearly depleted. Replace the batteries with new ones.
• A commercially available USB AC adaptor (5 V⎓/500 mA or greater) is required to power this unit via the USB port. Some USB AC adaptors may not work with this instrument, depending on the manufacturer and type.
• When turning the unit over, be careful so as to protect the buttons and knobs from damage. Handle the instrument carefully; do not drop it or allow it to topple over.
• When attaching the sound module or adjusting the angle, be careful not to get your fingers pinched between the movable parts and this unit. In places where small children are present, make sure that an adult provides supervision and guidance.