EFFECTS section

This section is used for applying effects to the sound.

MEMO

If you’re viewing this content on your smartphone, we recommend that you turn your smartphone on its side for landscape mode.

Controller (Parameter name)	Value	Explanation
[DELAY] slider (Part Delay Send Level)	0–127	Sets the amount of delay for the selected part. If you don’t want to add the delay effect, set this to 0.
[TIME] slider (Delay Time)	1–1300 (msec) (when SYNC is “OFF”)	Sets how long it takes for the second delay sound to play after the original sound is heard. Refer to “Delay parameters” to set the SYNC.
“About note values” (when SYNC is “ON”)
[FEEDBACK] slider (Feedback)	0–+98 (%)	Sets the ratio of delay that is returned to the input.
[REVERB] knob (Part Reverb Send Level)	0–127	Sets the amount of reverb for the selected part. If you don’t want to add the reverb effect, set this to 0.
[TIME] knob (Reverb Time)	0.1–10.0 (sec)	Adjusts the decay length of the reverb sound.

Controller

(Parameter name)

Value

Explanation

[DELAY] slider

(Part Delay Send Level)

0–127

Sets the amount of delay for the selected part.

If you don’t want to add the delay effect, set this to 0.

[TIME] slider

(Delay Time)

1–1300 (msec)

(when SYNC is “OFF”)

Sets how long it takes for the second delay sound to play after the original sound is heard.

(when SYNC is “ON”)

[FEEDBACK] slider

(Feedback)

0–+98 (%)

Sets the ratio of delay that is returned to the input.

[REVERB] knob

(Part Reverb Send Level)

0–127

Sets the amount of reverb for the selected part.

If you don’t want to add the reverb effect, set this to 0.

[TIME] knob

(Reverb Time)

0.1–10.0 (sec)

Adjusts the decay length of the reverb sound.

Controller	Explanation
[DELAY/REVERB] button	Lets you configure the effects.
	dLy	Configures the delay settings. For details, refer to “Delay parameters”.
	rEU	Configures the reverb settings. For details, refer to “Reverb parameters”.
CHORUS [I] button, CHORUS [II] button	Turns chorus I, II and I + II (when pressed at the same time) on/off. Long-press the button to configure the effect. For details, refer to “CHORUS & MFX parameters”.