Sampling settings
You can edit the sampling parameters (recording settings) for this unit.
- Press the [SAMPLING] button.
- The unit enters sampling mode.
- Use the following controllers to configure the sampling parameters.
Controller | Value | Explanation |
|---|---|---|
[LO-Fi] button (The sample rate changes each time you press the [LO-Fi] button.) | Sets the sample rate. | |
44.1k The [LO-Fi] button lights up dimly | The unit samples at 44.1 kHz. | |
22.0k The [LO-Fi] button is lit | The unit samples at 22.05 kHz. | |
14.7k The [LO-Fi] button blinks rapidly | The unit samples at 14.7 kHz. | |
11.0k The [LO-Fi] button blinks | The unit samples at 11.025 kHz. | |
[DELETE] button | Switches the mic on/off (mic mute). | |
The [DELETE] button is lit | Mutes the mic. | |
The [DELETE] button lights up dimly | Enables the mic. | |
[PITCH] knob | Sets whether to sample in mono or in stereo. | |
÷ono | The unit samples in mono. | |
StEr | The unit samples in stereo. | |
[START] knob | Sets the sample length. MEMO The length you can set depends on the tempo, sample rate and mono/stereo setting. | |
FREE | Sampling stops when you press the [SAMPLING] button. MEMO Refer to “Maximum sample time” in the main specifications for the maximum time available for each sample. | |
÷.1/4 (1 out of 4 beats in a measure), ÷.2/4 (2 out of 4 beats in a measure), ÷.3/4 (3 out of 4 beats in a measure), ÷. 1–÷. 29 | Sets the sample length (number of measures). | |
[END] knob | This sets the trigger that’s used to start the sampling. | |
t.OFF | Press the [SAMPLING] button to begin sampling. | |
SynC | Either press the [SAMPLING] or [ø] button, or use start commands (FA)/stop commands (FC) input from an external MIDI device to start and stop sampling. | |
-3db–-24d (-3–-24dB) | Sampling begins once the audio input exceeds the level that’s set here. | |
[LEVEL] knob | G. 0–G.255 | Sets the mic sensitivity. Refer to “Adjusting the input level” for details. |
Turn the [PITCH] knob while holding down the [SHIFT] button | This executes step sampling, which creates a number of individual (split) samples based on the sampling time you specify with the [START] knob. A note number is assigned to each sample after sampling is finished. For details on step sampling settings, refer to “Creating equally-divided samples (step sampling)”. | |
S.OFF | The step sampling function is not used. | |
S. 2–S. 64 | Sets the number of individual slices (divisions of a sample) created by the step sampling function. | |