Adjusting the input level

You can adjust the input level of the built-in mic or the headset mic used for sampling.

The actual input level can be adjusted while you’re checking it, so that you can set the optimal level.

  1. Press the [SAMPLING] button.
  2. The unit enters sampling mode.
  3. Check the step button indicators.
  5. Use the [LEVEL] knob to adjust the input level so that the [C]–[TIE] buttons (-3 to 0 dB) occasionally light up.

MEMO

  1. The input peak level is shown when you press the [SHIFT] button.
  2. When you’re sampling (or resampling) what you play on the sample pads, use one of the following methods to adjust the sample volume.
  3. Exit sampling mode, and then use the [LEVEL] knob to adjust the volume for each sample pad.
  4. Use the “Volume” parameter to adjust the volume for the entire pattern.
  5. If the sound input to the MIX IN jack sounds distorted even though the 0 dB segment on the level meter doesn’t light up, adjust the volume in one of the following ways.
  6. Adjust the volume of the connected external devices.
  7. Adjust the “Ext. In Gain” parameter.