Extracting specific samples (pads) from a pattern

You can create a pattern using only specific samples that were taken from a pattern that you’ve inputted using multiple samples.

  1. Following the steps in “Copying the pattern of a pad”, press the source pattern (pad) and then the save destination pattern (pad).
  3. If you decide to cancel, press the [EXIT] button.

  4. MEMO

    1. If you use the bank [A/F]–[E/J] buttons to select the bank before pressing the pads, you can save the pattern to a different bank.
    2. You can use the [CTRL 3] knob to select a project, when saving the pattern to a different project.
  5. Press the [REMAIN] button.
  6. Samples (pads) that are used by a pattern light up dimly in white.
  7. Press the samples (pads) that you want to extract.
  8. The pads light up white.
  9. Press the [REMAIN] button.
  10. Press the [VALUE] knob or [COPY] button.
  11. The pattern for which only the selected samples are enabled is saved to the specified pad.

NOTE

Performing this operation overwrites (erases) the pattern in the copy destination pad.