PAD SETTING

Curve Type

Sets how the volume changes according to how hard you strike a pad.

Lin

This is the standard setting. This produces the most natural balance between playing dynamics and volume change.

Exp

Compared to “Lin”, playing strongly produces a greater change in volume.

Log

Compared to “Lin”, playing softly produces a greater change in volume.

Fix

Sets the volume at a fixed level of 127.

Threshold

1–100

This sets the minimum sensitivity of the pads, at which the trigger signal is received only when a pad is struck with at least a certain amount of force (velocity). This can be used to prevent a pad from sounding due to vibrations from other pads.

Gain

0–100

The sensitivity is adjusted with the curve as-is. The larger the value, the greater the sensitivity is when playing the pads.

Trig Span

1–10

Adjusts the sensitivity of the pads to repeated strikes. With lower values, the pads detect repeated strikes within a shorter time interval. Set this value higher if you don’t want the pad to accidentally detect repeated strikes.

LED Brightness

1–10

Sets the brightness of the indicators on the buttons and pads. This sets the brightness when the buttons or pads are highlighted.

LED Glow

1–10

Sets the brightness of the indicators on the buttons and pads. This sets the brightness when the buttons or pads are not highlighted.

Pad LED Mode

This selects the color of the pad illumination.

BUS

Pad Color <BUS>

The pads light up in the color set in “BUS COLOR”.

In this mode, the pad colors change according to the bus through which the sample audio is sent.

PAD

Pad Color <PAD>

The pads light up in the color set in “PAD COLOR”.

In this mode, the pad colors are set for individual pads (up to 16).

SAMPLE

Pad Color <SAMPLE>

In this mode, the pad colors are set for individual samples (up to 2,560).

For details, refer to “Setting the pad colors for each sample (Pad Color <SAMPLE>)”.

BUS1 Color

Default, 1–127, White

Changes the pad color for each bus through which sample audio is sent.

This can be set for BUS 1, BUS 2 and DRY respectively.

This is enabled when Pad LED Mode is “BUS”.

• Hold down the [SHIFT] button and turn the [VALUE] knob to change the value in steps of 10.

BUS2 Color

DRY Color

PAD-1–PAD-16

Default, 1–127, White

Specifies the colors of individual pads.

This is enabled when Pad LED Mode is “PAD”, and when a sample is either playing back or stopped while in sample mode.